Tak wygląda ten przycisk.
Masz też schemat z 2006 roku ,przycisk Overdrive to nr 2
Tu po angielsku procedura sprawdzenia poprawności działania tego przycisku;
The connector is the four-prong white one next to
the steering post. To access the connector, the front
rack and front fenders must be removed (see Section
.
1. Set the meter selector to the OHMS position.
2. Connect the red tester lead to one red/yellow
wire (red/white wire on some models); then connect
the black tester wire to the other red/yellow
wire (red wire on some models). The meter must
show less than 1 ohm.
3. Depress and hold the reverse override button.
The meter must show an open circuit.
4. Connect the red tester lead to the blue wire
(blue/white wire on some models); then connect
the black meter lead to the black wire (blue wire
on some models). The meter must show an open
circuit.
5. Depress and hold the reverse override button.
The meter must show less than 1 ohm.Nie tłumaczyłem dokładnie,w końcu to Twój quad nie mój,ale od przycisku overdrive wychodzi wiązka czterech kabli,dwa żółto czerwone ,jeden czarny i jeden niebieski,trzeba znaleźć pierwszą kostkę od przycisku,rozpiąć ją i wpiąć omomierz do obu przewodów żółto czerwonych,omomierz powinien wskazać poniżej 1 oma.
Dotyczy modelu 2006,jako że nie podałeś rocznika.